Security Ranger III Podręcznik Użytkownika Pobierz pdf (Strona 38)

Hardware

The Hardware Settings screen displays the communication

(COM) ports for the hardware attached to the handheld. The

COM ports will be set during training.

Changes should only be made under the direction of Badger

Meter Technical Support. If the COM ports must be adjusted,

follow these steps.

1. Tap Hardware on the Settings Menu to display the

Hardware tab on the Hardware Settings screen.

2. Tap a technology button. For example, ORION CE

Radio.

Result: The COM port selection screen displays a list of

COM ports.

Figure 60: COM Port settings

3. Use the up and down arrows to nd and select the

COM port setting. Then tap Select.

4. Tap Save to save the change or tap Cancel to return

to the Settings Menu without saving any changes.

Result: Italic font, as shown in the ORION CE Radio eld,

indicates the COM port setting was changed.

NOT:N For a complete list of valid COM ports, refer to "Valid

COM Ports" onpage112 in the Appendix.

Figure 61: COM Port changed

GPS Tab

The GPS tab on the Hardware Settings screen is used to

access the Baud rate and the COM port for the GPS.

The Trimble Ranger 3 has built in GPS which uses COM 2.

These settings should not be changed.

For additional information about the GPS, refer to "Working

with GPS" onpage102.

Figure 62: GPS settings

ORION® Automated Meter Reading System for Trimble® Ranger 3

Page 38 February 2013

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 123 124

Brak uwag

Security Ranger III Podręcznik Użytkownika Strona 38